Gembird EG-PM2-LAN Manuel d'utilisateur télécharger pdf (Page 12)

EG-PM2-LAN PROGRAMMABLE POWER

OUTLET STRIP WITH LAN INTERFACE

All brands and logos are registered trademarks of their respective owners

the excessive load first and then (after 2-3 minutes) press the main

rocker switch (Z) to restore the power supply (see Figure #3 above).

To be able to use EG-PM2-LAN you will now have to complete its

LAN configuration.

3.2. Preparing LAN configuration of EG-PM2-LAN

Before configuring EG-PM2-LAN hardware settings, please, let it

obtain its IP address. Follow the steps below:

 Make sure EG-PM2-LAN is connected to the local network with the

provided RJ-45 cable (option A - recommended)

NOTE: by default the factory setting of EG-PM2-LAN is DHCP enabled.

If your LAN has a router with built-in DHCP server (which is very

common) then EG-PM2-LAN will automatically get an IP address from

the DHCP server. Proceed to section 3.3 below in this case.

NOTE: you may prefer to connect EG-PM2-LAN directly to the

managing computer LAN adapter (network card) using the supplied

crossover RJ-45 cable (option B). You might need to use this option if

your LAN does not have DHCP server.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 64 65

Pas de commentaire

Gembird EG-PM2-LAN Manuel d'utilisateur Page 12